My Box Amp has a home.
Back on December 7th, I wrote about assembling the Box Amplifier Kit I purchased from the Maker SHED store. After assembling the kit, the amplifier tested perfectly. However, I was still looking for a box to install the kit in. I found what I was looking for at Michael’s arts and crafts store. Michael’s sells a variety of sturdy fiberboard boxes. The box I chose was the right size and only cost a couple of dollars. Although I ended up with a box that I had to buy rather than reusing something I picked out of the recycle bin, I’m really happy with the results.
So, how does it all sound? Freakin’ awesome. I’ve been plugging in my iPod, my electric guitar, my portable radio. Basically any portable device with an audio output. This Box Amplifier has great bass and you can actually crank it up pretty good. All powered by a 9-volt alkaline battery.
Below you can see the process I went through cutting holes to mount the speaker and control panel. My intention was to use as few tools as possible. I used a box cutter to cut the holes. It looks a little rough but in the end everything cleaned up nicely. Also, since I liked the “AMP” stamp from the box the kit shipped in (which was too small for the final installation), I decided to cut it away and attach it to the lid of amp box using spray adhesive. It definitely has that grungy, DIY, handmade look I was going for.
Thank You Maker SHED.
A big “Thank You” to the Maker Shed store for putting together another great kit. As a huge fan of Make Magazine, the folks at the Maker SHED store have helped renew my interest in DIY projects. You rock!